Hello, Im about to start fitting the worktops into my L shaped kitchen, but would like some advice on which direction to run the mitre joint, and the fitting sequence.
Got jig, decent 1/2" router etc as have done similar job once before, so halfway there.... Walls also reasonably true and will be tiling over.
Plan attached.
Its a straightforward L shape, but theres an annoying pillar to get around at end of the worktop run 1 that sits between two walls. This pillar is at the end away...
L shaped worktop with pillar - best way to orient joint?
Got jig, decent 1/2" router etc as have done similar job once before, so halfway there.... Walls also reasonably true and will be tiling over.
Plan attached.
Its a straightforward L shape, but theres an annoying pillar to get around at end of the worktop run 1 that sits between two walls. This pillar is at the end away...
L shaped worktop with pillar - best way to orient joint?
