Hi,
I am fitting my first kitchen worktop as DIY project.
I have cut my worktop Male & Female joints by using router and jig.
The question.....
Do i need to file or sand the cut end of the laminate so a tiny bevel is formed (on the top laminate surface)? so when i push the ends together (& tighten with bots) the colour filler will fill a tiny "grove" or should i leave as cut with the router?
I could not find any info to point me in the right direction, so please would one of you nice...
Kitchen Worktops - Joints
I am fitting my first kitchen worktop as DIY project.
I have cut my worktop Male & Female joints by using router and jig.
The question.....
Do i need to file or sand the cut end of the laminate so a tiny bevel is formed (on the top laminate surface)? so when i push the ends together (& tighten with bots) the colour filler will fill a tiny "grove" or should i leave as cut with the router?
I could not find any info to point me in the right direction, so please would one of you nice...
Kitchen Worktops - Joints