Is ColorFill a decent adhesive to use? I notice that they say 1 tube per 600mm worktop but not sure if that means 2 joints per tube or just one.
They show it just being used near the top edge of the joint rather than all over. Seems a little odd.
I assume that the solvent can be used to clean up once it's fully cured but can it?
What is the best way to use it any advice etc?
John
-
They show it just being used near the top edge of the joint rather than all over. Seems a little odd.
I assume that the solvent can be used to clean up once it's fully cured but can it?
What is the best way to use it any advice etc?
John
-