Hi,
Am fitting kitchen base units in L pattern. Short run is 1.8m, long run is 4.6m
My walls are not square, and I think I made the mistake of fitting the short run first (which is parallel to its wall), but the long run goes out (or will do), buy 30-40mm by the end.
If I had fitted the long run first I could have made this side parallel, and only gone out a smaller amount on the short run.
Q1. is 40mm acceptable over this difference - will it be noticeable once the worktop is down, or...
Base units going out 30-40mm on 4.5 run - acceptable?
Am fitting kitchen base units in L pattern. Short run is 1.8m, long run is 4.6m
My walls are not square, and I think I made the mistake of fitting the short run first (which is parallel to its wall), but the long run goes out (or will do), buy 30-40mm by the end.
If I had fitted the long run first I could have made this side parallel, and only gone out a smaller amount on the short run.
Q1. is 40mm acceptable over this difference - will it be noticeable once the worktop is down, or...
Base units going out 30-40mm on 4.5 run - acceptable?