lighting
Anyone tried Deltec LED striplights and similar under kitchen wall-units? http://www.ledbulbs.co.uk/delt...O9zauKvT1hJRoCPHvw_wcB ------------------------- Regards, Ebee (M I S P N)... lighting
View ArticleTall oven housing gap.
Hi all I have just installed a tall oven housing and 600 mm apt bosch oven both purchased from B&Q. The housing is configured for a 600 mm over as per the instructions but there is a gap above the...
View ArticleOven Draw things???
Hi All, I have fitted my new Kitchen and I had a couple bits not 100% sure about. Taped to the draws is what looks like a strut / pole and I understand that it is a pole for the pot draws and I would...
View Articleadhesive for kitchen wall panels
Hi I am fitting "Berry Alloc" laminate kitchen wall panels. They recommend their own adhesive but I am sure this will be more expensive than a similar product on Screwfix. Can anyone recommend which...
View ArticleExtractor ducting distance
Folks, I'm shortly to fit a new kitchen at home... planning is finished and cabinets ordered. Still to pick anciliaries, (sink, tap,tiles, etc..) This includes the extractor, which will be of the...
View ArticleSuspended Accoustic Ceiling
Need a wee bit of help here:..Have a shop to fit out and there is around 30m2 of ceiling work to do. anyone give me an indication on cost for supply and fit (600x600 grid) Thanks.
View ArticlePrice of installing a flat pack kitchen
Hello everyone, i am wondering if anyone could give me some advise on how much to charge for fitting a flat pack kitchen. Basically the job is not a straight forward "like for like" change. I've got...
View ArticlePlease help - fridge door refuses to open fully!
When opening the fridge this morning I heard a loud click and the door refused to open fully. It looks like the bottom hinge is the problem. I understand I will have to replace the hinge, however...
View ArticleTrying to fit integrated dishwasher / skirting board problem
Hi I'm afraid I'm a bit of a novice when it comes to this so please keep with me. I ordered an integrated cupboard door for my kitchen so that I could have an integrated dishwasher fitted. My husband...
View ArticleHanging wall units
I have to hang a corner wall unit, one face will go onto an exterior block wall, the other face will go onto a plasterboard "eggbox' wall, two layers of plasterboard with cardboard inside, the studs...
View ArticleCutting extractor chimney
Folks, New kitchen to be fitted shortly We're still deciding which extractor to buy, but it will probably be a chimney type. Depending on the EXACT positioning of this, horizontaly speaking, I may have...
View ArticleInduction hob installation
We've bought a Samsung induction hob and the installation guide says we need to install an insulation panel between the oven and hob. I called Samsung to find out what this panel is and they said they...
View ArticleRounded edge on laminate worktop
I'm not in the trade but I sumbled across the forum and hoped somebody may be able to advice. I am wanting a rounded edge to be cut for a breakfast bar I'm having in my new kitchen (purchased units but...
View ArticleJoining worktops end to end
Hi all What's the best joint to use when fitting worktops end to end? Was hoping just to cut a channel with a router and bolt them with butterfly bolts. It's a long room so the worktop is in 3 sections.
View ArticleEnd panels either side of freestanding range...
As above, do I need end panels on the units either side of the range cooker? As you won't see the unit sides or the ends of the plinths do I need end panels, seems a bit of a waste. Also, what gap...
View ArticleKitchen Fitter Wanted - Bolton
Hi All I'm trying to find a kitchen fitter in the bolton area that is able to fit a B&Q kitchen including fitted appliances and tilling the floor and walls - can anyone help? Thanks
View ArticleUnder cabinet vent
Hello, hoping someone can suggest a clever way to conceal a messy hole in the bottom of a wall cabinet. To cut a long story short, I had a very old boiler that was inside a wall cabinet. When the...
View ArticleHeat deflectors
Does anyone know where I can purchase those Heat deflectors which fit onto the oven housing to prevent the doors adjacent to the oven getting burned.
View ArticleSealing Edges of Flat-Pack Kitchen Units
I've read somewhere that it's a good idea to seal the edges of flat-pack panels if there's a likelihood of water ingress. What product should I be using to 'seal' the flat-pack panels? Cheers john
View ArticleFridge Freezer between two ovens
Hi guys / girls Any one got any input on whether this is possible, personally I don't think it's a problem as ovens these days don't tend to give off a lot of heat external heat, would just like to get...
View Article