Hi all, wondered if anyone has any experience with cutting a slightly off 90 degree mitre in a worktop?
It's a u shaped install and at both ends of the u are appliances which leave no room for adjustment whatsoever the worktop is exactly 600 deep and the appliances (integrated) plus doors plus pipes on the wall take up 592 so I can only scribe 5mm at most and still have an overhang.
So has anyone ever tried cutting a mitre at say 89.5 degrees? Perhaps by packing behind the relevant pin when...
Seeking help! Out of square room....
It's a u shaped install and at both ends of the u are appliances which leave no room for adjustment whatsoever the worktop is exactly 600 deep and the appliances (integrated) plus doors plus pipes on the wall take up 592 so I can only scribe 5mm at most and still have an overhang.
So has anyone ever tried cutting a mitre at say 89.5 degrees? Perhaps by packing behind the relevant pin when...
Seeking help! Out of square room....