Is it possible to cut a straight butt joint right next to a hob cut-out (right over adjacent units) ?
It obviously leaves a very thin remaining edge. Of course I would love to move the joint to a better position but the kitchen is in an upstairs flat and it's impossible to get a length over 1.8 m up and around stair turns. The other alternative is through an upstairs window but of course that requires some sort of lift. It's a very busy street with shops below. The only other alternative is...
Worktop joint.
It obviously leaves a very thin remaining edge. Of course I would love to move the joint to a better position but the kitchen is in an upstairs flat and it's impossible to get a length over 1.8 m up and around stair turns. The other alternative is through an upstairs window but of course that requires some sort of lift. It's a very busy street with shops below. The only other alternative is...
Worktop joint.