laminate worktop join greater than 90 degree's

Hi

Can anyone offer advice on how to join 2 worktops at about 110 degrees.

worktop hasn't been chosen yet, but is likely to be a laminate due to budget constraints.

I was originally thinking of butting a square edge laminate but have been put off these as the front edge may fail.

Would it be best to do the female masons mitre as normal, offer up the male side and mark it. then clamp the jig as firm as possible to router out the male?

Or does anyone know of an affordable (cheap sub...

laminate worktop join greater than 90 degree's