I have purchased a shallow, and two deep sets of Blum metabox drawer sides and runner rails for my kitchen. I didn't want soft close, because I am part disabled, and didn't want to walk into a drawer that takes 10 minutes to close.
However, my question is.....because i purchased just the drawer sides and runners, i was wondering what width malamine board will i need to cut for the drawer box bottom, and the back panel? They are going in a standard 18mm thick, 500mm wide melamine base...
Metabox drawer sides.
However, my question is.....because i purchased just the drawer sides and runners, i was wondering what width malamine board will i need to cut for the drawer box bottom, and the back panel? They are going in a standard 18mm thick, 500mm wide melamine base...
Metabox drawer sides.