Hi all.
Following reading some tips on here, I've just done my first two worktop corner joints using a new Erbauer 1/2-12.7 x 50.8 cutter.
It's a square side laminate worktop, where I have peeled the laminate off for the female joints and routed only the males to butt up to the female square edged sides in a 'U' layout (no hockey stick).
I cut the worktop with my circular saw and a guide, then used the router to slowly trim the last final 1mm of the males (at full depth).
The worktop cut...
Slight burr left on laminate worktop after cutting joint with router
Following reading some tips on here, I've just done my first two worktop corner joints using a new Erbauer 1/2-12.7 x 50.8 cutter.
It's a square side laminate worktop, where I have peeled the laminate off for the female joints and routed only the males to butt up to the female square edged sides in a 'U' layout (no hockey stick).
I cut the worktop with my circular saw and a guide, then used the router to slowly trim the last final 1mm of the males (at full depth).
The worktop cut...
Slight burr left on laminate worktop after cutting joint with router