Hi I'm hoping someone on here can give a bit of advise I'm a diyer on fitting a kitchen
The worktops have been fitted the cutout for the sink should have been 986x486mm but has been cut 990x490 so there is only 2mm all round for a granite sink to sit on
And the hob cutout sits 15mm to far back so for it to fit I would need to cut out the drawer unit back panel
The company thinks this is acceptable but I have my doubts
Any advice would be much appreciated
The worktops have been fitted the cutout for the sink should have been 986x486mm but has been cut 990x490 so there is only 2mm all round for a granite sink to sit on
And the hob cutout sits 15mm to far back so for it to fit I would need to cut out the drawer unit back panel
The company thinks this is acceptable but I have my doubts
Any advice would be much appreciated