Hi guys. I'm dry fitting new kitchen units and when it comes to the oven housing, if I were to cut out in the service void for pipes the back of the oven would hit gas and central heating pipes. (Previous oven was pushed up against these)
If I put the unit upto the pipes then worktop won't align properly with oven and the oven will stick out from other units.
So for this problem I can only think of two options..
1. Pay to get all pipes routed along the floor under oven.
2. Place a batten...
Extend kitchen worktop
If I put the unit upto the pipes then worktop won't align properly with oven and the oven will stick out from other units.
So for this problem I can only think of two options..
1. Pay to get all pipes routed along the floor under oven.
2. Place a batten...
Extend kitchen worktop