Hello All
My cabinets have a 40mm "service area" at the back. I'd like to run the outlet of the washing machine passed another cabinet into the sink cabinet where there is a standpipe. I was going to route it underneath but instructions say it should be kept at least 400mm off the ground with no dips.
So question is, can I notch a 40mm ish hole in the back (sides) of the cabinets to allow this outlet to pass through into the sink cabinet?
My cabinets have a 40mm "service area" at the back. I'd like to run the outlet of the washing machine passed another cabinet into the sink cabinet where there is a standpipe. I was going to route it underneath but instructions say it should be kept at least 400mm off the ground with no dips.
So question is, can I notch a 40mm ish hole in the back (sides) of the cabinets to allow this outlet to pass through into the sink cabinet?