Morning,
Overshot 1/2" router bit in the end-grain of a belfast sink cutout. Photo below.
Oak worktop, currently unfinished and will be finished with danish oil.
I'm looking for a filler that will be robust enough for this large fill at the the edge of the sink but will still take the oil - I have a concern that a 2-part will not change colour with the oil?
Any ideas or experiences?
Thanks.
![[IMG]]()
Overshot 1/2" router bit in the end-grain of a belfast sink cutout. Photo below.
Oak worktop, currently unfinished and will be finished with danish oil.
I'm looking for a filler that will be robust enough for this large fill at the the edge of the sink but will still take the oil - I have a concern that a 2-part will not change colour with the oil?
Any ideas or experiences?
Thanks.
![[IMG]](http://media.diynot.com/99000_98371_78161_21707968_thumb.jpg)