Hi,
Fitting my first kitchen and have made a mistake.
I have built a peninsular to house under counter integrated seperate fridge and freezer. I have screwed and glued the seperating panel on the bottom and at back but have now realised it sticks out further than the end panel, its only a few mm but will be noticeable once the worktop goes on. I have used evo stick like s*** turbo.
Question is can i undo this so i can cut a few mm off the back of the panel? Would a hammer and chisel do...
UNDOING MISTAKE - Evo-Stik EVO-STIK STICKS LIKE **** TURBO GRAB ADHESIVE
Fitting my first kitchen and have made a mistake.
I have built a peninsular to house under counter integrated seperate fridge and freezer. I have screwed and glued the seperating panel on the bottom and at back but have now realised it sticks out further than the end panel, its only a few mm but will be noticeable once the worktop goes on. I have used evo stick like s*** turbo.
Question is can i undo this so i can cut a few mm off the back of the panel? Would a hammer and chisel do...
UNDOING MISTAKE - Evo-Stik EVO-STIK STICKS LIKE **** TURBO GRAB ADHESIVE